You are at:Home»

Genie

Topics Engaged In

Viewing 15 topics - 16 through 30 (of 35 total)

- Untethered mode
  Started by: megatron in: General 3D Printer Discussion Last post: Genie — 9 years, 10 months ago
- 2 Voices
  
  2 Posts
- Voltage for Dimensional Motors
  Started by: Mage in: General 3D Printer Discussion Last post: Genie — 9 years, 10 months ago
- 2 Voices
  
  2 Posts
- Motors
  Started by: megatron in: General 3D Printer Discussion Last post: Genie — 9 years, 10 months ago
- 2 Voices
  
  2 Posts
- Sides of the print getting distorted
  Started by: megatron in: General 3D Printer Discussion Last post: Genie — 9 years, 10 months ago
- 2 Voices
  
  2 Posts
- Extruder Offset
  Started by: Anonymous in: General 3D Printer Discussion Last post: Genie — 9 years, 10 months ago
- 2 Voices
  
  2 Posts
- Non Manifold geometry
  Started by: Watson_Jr in: General 3D Printer Discussion Last post: Genie — 9 years, 10 months ago
- 2 Voices
  
  2 Posts
- Print getting distorted
  Started by: Mage in: General 3D Printer Discussion Last post: Genie — 9 years, 10 months ago
- 2 Voices
  
  2 Posts
- Power Failure
  Started by: Anonymous in: General 3D Printer Discussion Last post: Genie — 9 years, 10 months ago
- 2 Voices
  
  2 Posts
- Differentiating Materials
  Started by: megatron in: General 3D Printer Discussion Last post: Genie — 9 years, 10 months ago
- 2 Voices
  
  2 Posts
- Torture Test
  Started by: michael101 in: General 3D Printer Discussion Last post: Genie — 9 years, 10 months ago
- 2 Voices
  
  2 Posts
- Effects of Humidity
  Started by: michael101 in: General 3D Printer Discussion Last post: Genie — 9 years, 11 months ago
- 2 Voices
  
  2 Posts
- Good material for dolls
  Started by: Anonymous in: 3D Printer Filament & Materials Last post: Genie — 9 years, 11 months ago
- 2 Voices
  
  2 Posts
- Printer is Shaking
  Started by: Anonymous in: MakerBot 3D Printer Discussion Last post: Genie — 9 years, 11 months ago
- 2 Voices
  
  2 Posts
- Different patterns appearing on the bottom of print
  Started by: Anonymous in: General 3D Printer Discussion Last post: Genie — 9 years, 11 months ago
- 2 Voices
  
  2 Posts
- Optimum temperature for PLA
  Started by: michael101 in: 3D Printer Filament & Materials Last post: Genie — 9 years, 11 months ago
- 2 Voices
  
  2 Posts

Viewing 15 topics - 16 through 30 (of 35 total)