[Mage]

Mage on January 24, 2015 at 4:32 pm #1840

The prints come out well in the beginning but for the fact that I notice a slight distortion starts to set in as the print progresses. I am unable to understand the reason. I am hoping to find some answers here.

[Genie]

Genie on January 29, 2015 at 4:13 pm #1853

Hello Mage

From what I understand from your post, your print is getting warped. This usually happens during the cooling down process of the print. Sometimes they shrink causing the print to warp. This can be solved by using a heated bed. This ensures that the base is heated up and sticks to the platform. Another solution is to use glue. Just ensure that you spread the glue evenly to form a flat surface. You can spread it using a paper too.