You are at:»»Sides of the print getting distorted

Sides of the print getting distorted

Posted In: General 3D Printer Discussion

  • Participant
    megatron on December 16, 2014 at 12:55 pm #1758

    Hi there

    I have been trying to print a samll sample which has flat sides. On completion of the print I have noticed that the base has risen up a little bit. Is this normal, I want the base to be flat, flush to the surface. Any tips on how to avoid it?

    Participant
    Genie on February 14, 2015 at 3:02 pm #1870

    Hello Megatron

    The symptoms stated by you are seen when the layers cool down unevenly. Because of difference in temperatures, the model can curl out or shrink in. The solution to this problem is to use a Raft. Raft is a part added beneath the model. It separates the model and preheated build plate. Raft is so built that it can be easily removed from the model, leaving the base intact. This separation helps in reducing the temperature differences, thereby saving your model from distortion

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.